In previous releases when doing a Transient stress (modal superposition) analysis, say with a sinusoidal force input at some node, the model results would represent that sinusoidal force as a varying arrow in the animation. The force is not shown in Simulation Mechanical 2014. Is there a way to get it to show? One reason I would like to see it is because when I open an old model with many nodes I know which node the load is applied to, but it is almost impossible to find the node if there are thousands in the model. Thanks. Phil. pjquenzi@gmail.com
![Autodesk Design & Make Report](https://forums.autodesk.com/t5/image/serverpage/image-id/1350519iCB55845EBFC43016/image-size/large?v=v2&px=999" "Autodesk Design & Make Report")