Transient heat transfer -Different load cure per heat generation

[Anonymous]

Hi,

I try perform transient heat analysys, there's several heat generator in my analysis.

I would like to apply different load curve for each generator. For example one 80% at start for 2 hours then 60% for 3 hours other 20% for 2 hours at start then 10% for 3 hours.

But my load cuve parameters apply to all heat generators besides the fact they're in different heat generators group. if i modify one it applies to all the other ones.

anyway to make them independent?

Thanks for reply,

Regards

[Anonymous]

See attached file for better explanations^^

[Anonymous]

Got my answer, You have to create multiple load curve by incremented load curve number^^ (I was thinking it was just a switch On/OFF 😞 )