SImulation won't solve after it outputs available hard disk space

[mschroepfer]

I cannot get simulation to solve.  It solved my first load case just fine.  I copied my first load case and added a centrifical load.  It stops solving after it outputs the available hard disk space.  See attached log file.  Any suggestions please?

Thanks,

MIchael

Engineer

Polar Tank Trailer

[Andrew.Sartorelli]

Hi Michael,

From the log it looks like you are getting a warning:

 Warning: Rotation rate set but no load case multiplier set

You may need to set the load multiplier in Analysis Parameters for your angular velocity.
______________________________________________________________

If my post answers your question, please click the "Accept as Solution" button. This helps everyone find answers more quickly!

[mschroepfer]

That is not a problem.  I tried adding multipliers of 1 on the load cases.

[Andrew.Sartorelli · Accepted solution]

It looks like you are using Simulation Mechanical 2013.00, I'd recommend upgrading to Simulation Mechanical 2013.20 or if you have subscription 2015 R1. There were a few issues in the first service pack for 2013 that seem related to the issue that you are having:

• The results are not correct when load cases are calculated beyond the first one.
• Linear analysis with Centrifugal load does not run with certain mesh size.

______________________________________________________________

If my post answers your question, please click the "Accept as Solution" button. This helps everyone find answers more quickly!