Simulation Mechanical and Multiphysics

Reply
Valued Contributor
66 Posts
2 Kudos
Registered: ‎04-06-2013

Meshing problems

121 Views, 1 Replies
10-03-2013 05:21 AM

Hi,

 

I'm evaluating Mechanical Simulation.

When meshing an assembly, I very often see that the progress bar is running to its maximum while not all parts are meshed yet (see picture).

The only thing I can do is click Close. The assembly is not meshed after that. Sometimes there is also an Error Report.

There is no other information about what could be wrong.

 

Any idea what is wrong?

 

meshcrash.jpg

Employee
269 Posts
12 Kudos
Registered: ‎10-04-2010

Re: Meshing problems

10-04-2013 09:33 PM in reply to: mechamania

It seems that the mesh process is stuck at some points and does not finish.  If the mesh size is too small, you can increase the mesh size and try.

 

-Shoubing