I found a bug when you run a Single Analysis with Multiple Load Cases

[jiaming0503]

 I found a bug for Autodesk simulation multiphsics2013.

 When you used a Single Analysis with Multiple Load Cases, you will found the results were wrong from load case2 to the end.

 Did anyone meet this problem?

[jiaming0503]

But the load case1 were reasonable.

And the analysis results haven't this problem when used previous versions.

[AstroJohnPE]

Hi everyone,

That bug was fixed in 2013 Service Pack 1 (SP1). The current version is service pack 2. So please update your software to the current version.

If I remember correctly, the multiple load case bug depended on the size of the model, so the results were not always incorrect.

[jiaming0503]

Thanks for your help!