Discussion Groups

Simulation CFD

Reply
Contributor
11 Posts
0 Kudos
Registered: ‎08-21-2013
Accepted Solution

Use of Microns instead of Millimeters

174 Views, 1 Replies
09-24-2013 08:07 AM

Dear all,  I would like to know how to set up the analysis in microns units instead of millimeters. I know how to change from meter, CM and mm but there is no option for microns. My original assembly is in microns in Inventor and when launched into CFD 360 2014 I can only select mm as the smallest scale. Or if this is not possible how to reduce the size of the "small objects" as when I try to mesh at micron scale it tells me it should be bigger than the small scale size.

Regards,

David

Product Support
1,062 Posts
149 Kudos
Registered: ‎08-25-2011

Re: Use of Microns instead of Millimeters

09-24-2013 10:17 AM in reply to: bulnes

Hi David,

 

You cannot change the CFD units to microns. As a workaround could I suggest changing the Inventor units to mm?

The meshing issue may not be related but this would be a good test.

 

Kind regards,

Jon



Jon Wilde