simulation cfd 2013 result problem

[mili5500]

i read every toturials about thermal comfort

i model a room with an occupant,i tried to inter a 0.1 m/s velocity to the room with boundry condition on window

the first few times i get the result but now it show temperature without change inside of the room and the plane result doesnt work anymore,i tried to reinstall it but nothing happend,i really need help bcuz i need those result for my thesis

[mili5500]

my model is 4 X 4 x 4 meter,that was my hypothesis

Thanks

Milad

[Jon.Wilde]

Hopefully you have this sorted now. I cannot really make anything out regarding meshing.

I would take a look at it as shaded (not wireframe). 2 elements through the walls is a minimum. 
Also add a cut-plane and take a look at the mesh there (show cut-plane as shaded by mesh).

Please let us know if this is now working OK.

Regards,

Jon

[mili5500]

but this model is 10 by 10 and 4 meters in height

[Jon.Wilde]

OK, that is fine. Changing it to mm, will give you 4000mm height, spot on.

Right now your model is 4km high. Check the units within CFD, perhaps they are not set the same as your CAD system. Typically this does not happen but I have seen it before.

Jon