Discussion Groups

Simulation CFD

Reply
Member
3 Posts
0 Kudos
Registered: ‎09-26-2012
Accepted Solution

Particle Analysis_Cleanroom Industry

178 Views, 2 Replies
10-30-2012 11:57 PM

 

Hi,

In Boundary Condition Section. Can we also set the number of particle that produce by machine/human in our cleanroom?

 

Product Support
1,062 Posts
147 Kudos
Registered: ‎08-25-2011

Re: Particle Analysis_Cleanroom Industry

10-31-2012 09:00 AM in reply to: EMS_Toptrans

Hi,

 

You could try using flow traces after the analysis is complete, this would show you where any particles that are produced eventually end up.



Jon Wilde
Product Support
662 Posts
232 Kudos
Registered: ‎08-24-2011

Re: Particle Analysis_Cleanroom Industry

11-01-2012 02:25 PM in reply to: wildej

You might also want to checkout the particle trace grid spacing workflow.  This way you can control the number of particles you want to simulate.

 

What is your goal with using the particles traces?

 

http://wikihelp.autodesk.com/Simulation_CFD/enu/2013/Help/0012-What_s_N12/0015-Workflow15

 

-Royce



Royce Abel