Community
CFD Forum
Welcome to Autodesk’s CFD Forums. Share your knowledge, ask questions, and explore popular CFD topics.
cancel
Showing results for 
Show  only  | Search instead for 
Did you mean: 

how to handle two fluid in one model

6 REPLIES 6
SOLVED
Reply
Message 1 of 7
jaiminthejack
581 Views, 6 Replies

how to handle two fluid in one model

Basically i want try on counterflow heat exchanger.

 

by void i create 1 volume for 1 fluid say-water 

 

but how to create other ex.like gas,air?

 

6 REPLIES 6
Message 2 of 7
Jon.Wilde
in reply to: jaiminthejack

You can use the same approach. Build Surfaces and Fill Void.

 

A better method is to add solid cylinders, extruded in CAD (3x dia inlet and 5x dia outlet), leaving the 2 internal sections hollow but sealed.

When you launch, CFD will automatically fill them for you.

 

The advantage of this is reduced work in CFD and also the extensions will ensure you have well developed flow before the fluid enters the model and prevents recirculation over the outlet Boundary Conditions.

Message 3 of 7
jaiminthejack
in reply to: Jon.Wilde

Message 4 of 7
jaiminthejack
in reply to: Jon.Wilde

 
Message 5 of 7
Jon.Wilde
in reply to: jaiminthejack

Looks like that should work, does it not?

 

Also, you may wish to consider running a 1/2 model to speed up the process, using a Slip/Symmetry BC along the cut-plane.

Message 6 of 7
jaiminthejack
in reply to: Jon.Wilde

will u demonstrate it?

 

still m learining this software

Message 7 of 7

You should be able to do the full model yourself pretty easily.

With the Void Fill tool you would seal all four openings (Red Arrows)

Whether you get 1 or 2 fluid volumes will depend on the cad model. If your baffles are sealed (Orange Arrows)

then you should get 2 volumes, otherwise it will be treated as 1 continuos fluid domain.

HX.jpg

 

 

The aspect Jon mentioned for Half-Symmetry is very useul as it will reduce the overall model and computational resources.

To do that you would have to do an extrude-cut to get 1/2 the model (similar to the sliced view you have here).

Then you would mate an additional large flat plate to the "cut" side. This will help seal the openings length-wise.

This flat plate will get suppressed in the meshing dialog and not be part of the simulation

You will then build your Inlet and Outlet caps to seal the domain and have your interior fluid volumes generated.

Slip/Symm boundary conditions will be assigned to all Fluid faces that are on the Symmetry plane.

 

If you are just starting out, it may be worthwhile starting with fewer pipes (length-wise) so that you can get comfortable with the workflow and running and you can always add the complexity back in.

Apolo

Can't find what you're looking for? Ask the community or share your knowledge.

Post to forums  

Autodesk Design & Make Report