Discussion Groups

Robot Structural Analysis

Reply
Active Contributor
tord
Posts: 35
Registered: ‎07-10-2012
Accepted Solution

Working with reinforcenent

531 Views, 6 Replies
02-18-2013 03:05 PM
Can you please help me with a guide (step by step) how to use "Plate reinforcement" (-Bending, -Required, -Provided)
The manual is too old and it is not describing how to use this parts.
Another qustion is how i can make a plate without reinforcement at the top of the plate?
I have no bending moments at the top (maybe very small)
Thank in advance / Tord
Please use plain text.
Product Support
Rafal.Gaweda
Posts: 5,315
Registered: ‎04-26-2010

Re: Working with reinforcenent

02-19-2013 12:59 AM in reply to: tord


Can you please help me with a guide (step by step) how to use "Plate reinforcement" (-Bending, -Required, -Provided)
The manual is too old and it is not describing how to use this parts.

Take a look at movies
http://www.robotoffice.com/rsa/

Another qustion is how i can make a plate without reinforcement at the top of the plate?
Rather not possible. Minimum reinforcement will be generated.
You can also try to play with covers to get "almost" one layer reinfrocement


Rafal Gaweda
Please use plain text.
Product Support
Rafal.Gaweda
Posts: 5,315
Registered: ‎04-26-2010

Re: Working with reinforcenent

02-19-2013 01:21 AM in reply to: Rafal.Gaweda

or with the settings below min reinforcement will not be calculated if not required (from calculation \ design point of view).

 

minreinf1.jpg



Rafal Gaweda
Please use plain text.
Active Contributor
tord
Posts: 35
Registered: ‎07-10-2012

Re: Working with reinforcenent

02-19-2013 09:25 AM in reply to: tord

Thank you, it helped a lot. there were very good videos.

Do you have more of those?

 

/ Tord

Please use plain text.
Product Support
Rafal.Gaweda
Posts: 5,315
Registered: ‎04-26-2010

Re: Working with reinforcenent

02-20-2013 12:24 AM in reply to: tord
Please use plain text.
Active Contributor
tord
Posts: 35
Registered: ‎07-10-2012

Re: Working with reinforcenent

02-20-2013 02:02 PM in reply to: Rafal.Gaweda

Thanks Rafael

But I still can´t see anything describing how to work with the "Bending-/Required-/Provided- reinforcement" and what I can do in theese dialogs.

(See attached files)

 

/ Tord 

Please use plain text.
Product Support
Rafal.Gaweda
Posts: 5,315
Registered: ‎04-26-2010

Re: Working with reinforcenent

02-21-2013 01:01 AM in reply to: tord
Please use plain text.