Community
http://screencast.com/t/4shCTG1YO
Things I tried
1- re-doing the cladding
2- inverting panel Z local axis
3- Open file in repair mode (all screenshots are blank!!!)
4- At the end of this movie , if I run the model again , the load and panel local axes go back to correct position!!!
seems like a graphical issue that is triggered if previewing ANY of the screenshots in Printout composition.
Rafael Medeiros
Did you find this post helpful? Feel free to Like this post.
Did your question get successfully answered? Then click on the ACCEPT SOLUTION button.
rename to . rar
Rafael Medeiros
Did you find this post helpful? Feel free to Like this post.
Did your question get successfully answered? Then click on the ACCEPT SOLUTION button.
Can't find what you're looking for? Ask the community or share your knowledge.
Post to forums
![Autodesk Design & Make Report](https://forums.autodesk.com/t5/image/serverpage/image-id/1350519iCB55845EBFC43016/image-size/large?v=v2&px=999" "Autodesk Design & Make Report")