Discussion Groups

Robot Structural Analysis

Reply
Mentor
andrea.pontiggia
Posts: 179
Registered: ‎01-29-2012
Accepted Solution

Two problems

228 Views, 4 Replies
09-22-2012 01:28 AM

Hello, I have two problems:

-as I can orient the reference system more panels in the same direction automatically?

-in a model I find this problem, but I can not figure out where the model is wrong?

(i attach the file)

Cattura.JPGCatra.JPGthanks

Andrea
Please use plain text.
*Expert Elite* | International Moderator
Romanich
Posts: 584
Registered: ‎09-29-2009

Re: Two problems

09-22-2012 02:11 AM in reply to: andrea.pontiggia

Hi,

answer for your first question is Yes. 

local.png

 

   
Please use plain text.
Product Support
Rafal.Gaweda
Posts: 5,587
Registered: ‎04-26-2010

Re: Two problems

09-24-2012 01:36 AM in reply to: andrea.pontiggia

 

-in a model I find this problem, but I can not figure out where the model is wrong?

 

I will check the model but take a look at this thread http://forums.autodesk.com/t5/Autodesk-Robot-Structural/Error-Nr-100/m-p/3602456/highlight/true#M713...

 



Rafal Gaweda
Please use plain text.
Product Support
Rafal.Gaweda
Posts: 5,587
Registered: ‎04-26-2010

Re: Two problems

09-24-2012 01:51 AM in reply to: Rafal.Gaweda

It is caused by not connected rigid link and some nodes not connected to bars located on claddings egdes \ corners.

 

e100.jpg

 

Corrected file attached.

 



Rafal Gaweda
Please use plain text.
Mentor
andrea.pontiggia
Posts: 179
Registered: ‎01-29-2012

Re: Two problems

09-24-2012 08:08 AM in reply to: Rafal.Gaweda

thank you very much

Andrea
Please use plain text.