Discussion Groups

Robot Structural Analysis

Reply
Active Member
jfmh
Posts: 9
Registered: ‎03-06-2013
Accepted Solution

Structure verification - The load has not been distributed correctly

491 Views, 3 Replies
10-02-2013 09:07 AM

Hi!

 

I have a problem in panels without FE. In the verification of the structure the following error occurs in some panels: "The load has not been distributed correctly. there are no objects or elements carrying the load overlap". I can not get understand this error.

The file is attached to be easier to understand the problem.

Please use plain text.
Product Support
Artur.Kosakowski
Posts: 4,973
Registered: ‎12-17-2010

Re: Structure verification - The load has not been distributed correctly

10-02-2013 11:41 PM in reply to: jfmh

1. Increase the tolerance to 2 mm

2. To distribute the load the cladding has to be supported either by panel edges or bars. You need to add dummy bars (or replace each of the two the vertical panels with two smaller with edges at this level) under claddings 912 and 913.

 

If you find your post answered press the Accept as Solution button please. This will help other users to find solutions much faster. Thank you.



Artur Kosakowski
Please use plain text.
Active Member
jfmh
Posts: 9
Registered: ‎03-06-2013

Re: Structure verification - The load has not been distributed correctly

10-03-2013 04:46 AM in reply to: Artur.Kosakowski

Thanks Artur

 

In relation to item 2, I get it and I resolved.

But in relation to item 1, when I insert a tolerance of 2 mm, a new warning appears : "Cohesion of the calculation model has been provided by definition of the kinematic constraints in incoherent points of the finite elements mesh". how can I fix the problem?

The file is attached to be easier to understand the problem.

Please use plain text.
Product Support
Artur.Kosakowski
Posts: 4,973
Registered: ‎12-17-2010

Re: Structure verification - The load has not been distributed correctly

10-03-2013 05:18 AM in reply to: jfmh
Please use plain text.