Discussion Groups

Robot Structural Analysis

Reply
Active Member
6 Posts
0 Kudos
Registered: ‎04-20-2013

Re: Spiral stair slab

10-27-2013 08:27 AM in reply to: HoshangMustafa

Thank you very much for the video, I do every step in the video until I reach to the polyline command I pick the points using the grids on the screen (no coordinates) and there was nothing drawn by this command 

I don't really know where is the problem, if i choose contour the lines appear but i choose line or polyline there is nothing on the screen.

 

my best regards

Distinguished Contributor
223 Posts
17 Kudos
Registered: ‎01-12-2013

Re: Spiral stair slab

10-27-2013 11:56 PM in reply to: ce_ng2012

Have you tried reducing the graphic hardware acceleraction level?

Tools --> Preferences --> View Parameters

Reduce "Display acceleration" slider, restart Robot and then try it again.

INTELIKA

Mirko Jurcevic M.Eng.
INTELIKA d.o.o.
www.intelika.hr
Active Member
6 Posts
0 Kudos
Registered: ‎04-20-2013

Re: Spiral stair slab

10-28-2013 12:37 PM in reply to: ce_ng2012

Hi to you all

 

Thank you Eng. Mirko Jurcevic it works at last.

Valued Contributor
82 Posts
13 Kudos
Registered: ‎02-15-2014

Re: Spiral stair slab

10-03-2014 10:52 AM in reply to: Romanich

asd.JPG