Robot Structural Analysis Forum
Welcome to Autodesk’s Robot Structural Analysis Forums. Share your knowledge, ask questions, and explore popular Robot Structural Analysis topics.
cancel
Showing results for 
Show  only  | Search instead for 
Did you mean: 

Source of DSC Algorithm warning

3 REPLIES 3
Reply
Message 1 of 4
Andrey_Golenkin
562 Views, 3 Replies

Source of DSC Algorithm warning

Hi Guys,

 

There is an old issue with DSC algorithm. In my model when I try to calculate it is mandatory to switch DSC on, otherwise Robot refuses to calculate. But I cannot understand why there is need for DSC when I do not have elastic or non-linear releases.

 

Previously I encountered such problem few times and for small models It wasn't a problem, but for relatively big models it considerably increases model generation time.

 

Any help appreciated. Thanks in advance.

 

DSC_Warning_Model

Andrey Golenkin,
Structural Engineer
3 REPLIES 3
Message 2 of 4

Verification corrected in v.2014
DSC not needed in this case \ model.


Rafal Gaweda
Message 3 of 4

Unfortunately this model was made in 2013 and when we open it in 2014 all labels (support, releases, member types etc.) bacome uneditable (on my opinion because of cyrillyc fonts correction in 2014). Is there any other way to bypass this DSC check in 2013?

Andrey Golenkin,
Structural Engineer
Message 4 of 4

Turn on DSC in Job Preferences
Labels are editable but not readable but you can change names in 2014


Rafal Gaweda

Can't find what you're looking for? Ask the community or share your knowledge.

Post to forums  

Autodesk Design & Make Report