Community
Two issues here:
1. Import of non linear combinations to the RC Wall module is currently not supported
2. For a retaining wall I would personally use the approach illustrated on the attached picture as in fact your primary design factor is IMHO bending rather than in plane tension / compression
If you find your post answered press the Accept as Solution button please. This will help other users to find solutions much faster. Thank you.
Artur Kosakowski
Can't find what you're looking for? Ask the community or share your knowledge.
Post to forums
![Autodesk Design & Make Report](https://forums.autodesk.com/t5/image/serverpage/image-id/1350519iCB55845EBFC43016/image-size/large?v=v2&px=999" "Autodesk Design & Make Report")