RC BEAMS - SNIP - Area steel ?

[Anonymous]

Hi.. I is Prolem 

I use code Snip 2.

[Anonymous]

Please. I is need. Thak

[Artur.Kosakowski · Accepted solution]

Here you are.

[Anonymous]

Thanks. Athur

[Anonymous]

Hi. I is prolem

Question 1. picture 1

Conver c of picture right ???

Question 2. Pticture 2

Why c=0????

I attment file picture under.

thanks

[Artur.Kosakowski]

Looking at the rtd file you sent the cover is displayed as 20 mm. Could you sen the rtd file where you have it displayed as 0 mm in the calculation note?

[Anonymous]

Is here.

Thanks. 

[Artur.Kosakowski]

Thank you for the file. As far s I can see the 0 values are displayed when covers are locked. As you have the reinforcement frozen calculations of the beam will not change it therefore you can unmark these check boxes to have the correct value displayed in the calculation note.

[Anonymous]

Thank Artur.

But If I not Fixed. As (robot) > As( hand).

[Artur.Kosakowski · Accepted solution]

1. Calculate beam with the fixed covers

2. Edit the value of covers in the calculation note or

2a. Freeze the reinforcement generated for the fixed covers

2b. Calculate the beam with frozen reinforcement again to have the 20 mm cover displayed in the note.