Community
I always tend to blame my crappy models for panel edge meshing problems. I try to use model correction only on the late stages of model development to prevent garbling and inconsistence of coordinates / nonplanar panels.
Yet this one hasn't subjected to double pass of model correction. I also tried to redefine the contour multiple times. all failed, not to mention that this all is obviously a non-optimal effort spending.
Mesh after several remodels and 1st model correction:
![ScreenClip [15].png](http://forums.autodesk.com/t5/image/serverpage/image-id/23113iA39280B7CDBB6DDC/image-size/original?v=mpbl-1&px=-1 "ScreenClip [15].png")
Mesh after 2nd model correction:
![ScreenClip [16].png](http://forums.autodesk.com/t5/image/serverpage/image-id/23111iE0A14F2CA0411B53/image-size/original?v=mpbl-1&px=-1 "ScreenClip [16].png")
Are there any workflow hints to prevent the workload-heavy remeshing and remodeling?
TIA
Model (zipped):
Hi Alex,
Try to use this meshing settings:
And you will receive nicely mesh:
Do you find the posts helpful? "LIKE" these posts!
Have your question been answered successfully? Click 'ACCEPT SOLUTION' button.
Roman Zhelezniak
Robot Evangelist & Passionate Civil Structural Engineer
Can't find what you're looking for? Ask the community or share your knowledge.
Post to forums
![Autodesk Design & Make Report](https://forums.autodesk.com/t5/image/serverpage/image-id/1350519iCB55845EBFC43016/image-size/large?v=v2&px=999" "Autodesk Design & Make Report")