Robot Structural Analysis

Reply
Mentor
faisal.aaouatif
Posts: 213
Registered: ‎10-08-2011

panel cut

321 Views, 5 Replies
12-22-2012 12:15 PM

when using panel cuts , we can study a hole moment diagram for a slab for example.

but , is there any way to extract quickly (automatically) values of moments in defined points (regular distribution of points) belonging to a cut ?

Thx

Please use plain text.
Product Support
Rafal.Gaweda
Posts: 5,604
Registered: ‎04-26-2010

Re: panel cut

12-23-2012 11:19 PM in reply to: faisal.aaouatif

See below

 

dar.jpg



Rafal Gaweda
Please use plain text.
Mentor
faisal.aaouatif
Posts: 213
Registered: ‎10-08-2011

Re: panel cut

12-24-2012 01:27 AM in reply to: Rafal.Gaweda

Thank you Rafal ,

Moving the mouse cursor over the diagram gives all the values needed.

to clarify my past question , i give the example below :

defining moments on Slab cut with 10 m long : instead of pointing twenty times ( every 0.50m ) the mouse cursor over the moment diagram , is there is a way ( table ) in whish we can have moment values every 0.50m.

Thank you

Please use plain text.
Product Support
Rafal.Gaweda
Posts: 5,604
Registered: ‎04-26-2010

Re: panel cut

12-24-2012 02:39 AM in reply to: faisal.aaouatif

the moment diagram , is there is a way ( table ) in whish we can have moment values every 0.50m.

 


I am afraid there is no such option.



Rafal Gaweda
Please use plain text.
Mentor
faisal.aaouatif
Posts: 213
Registered: ‎10-08-2011

Re: panel cut

12-24-2012 03:11 AM in reply to: Rafal.Gaweda

OK

Thank you VM

Please use plain text.
Valued Contributor
sergey.churilov
Posts: 77
Registered: ‎04-12-2012

Re: panel cut

01-10-2014 03:13 PM in reply to: faisal.aaouatif

Here is a hint for you:

 

- select the nodes that lie on the cut (or nodes close to the cut)

- show FE results, select the internal forces of interest

- filter the results to show only results for the selected nodes

- copy the filtered results to a spreadsheet program

 

P.S. Be careful of the order of the filtered results in the table. It might need slight reordering to match the node numbering in the cut.

 

Cheers

Please use plain text.