Discussion Groups

Robot Structural Analysis

Reply
Mentor
213 Posts
70 Kudos
Registered: ‎10-08-2011

panel cut

323 Views, 5 Replies
12-22-2012 12:15 PM

when using panel cuts , we can study a hole moment diagram for a slab for example.

but , is there any way to extract quickly (automatically) values of moments in defined points (regular distribution of points) belonging to a cut ?

Thx

Product Support
5,718 Posts
1,303 Kudos
Registered: ‎04-26-2010

Re: panel cut

12-23-2012 11:19 PM in reply to: faisal.aaouatif

See below

 

dar.jpg



Rafal Gaweda
Mentor
213 Posts
70 Kudos
Registered: ‎10-08-2011

Re: panel cut

12-24-2012 01:27 AM in reply to: Rafal.Gaweda

Thank you Rafal ,

Moving the mouse cursor over the diagram gives all the values needed.

to clarify my past question , i give the example below :

defining moments on Slab cut with 10 m long : instead of pointing twenty times ( every 0.50m ) the mouse cursor over the moment diagram , is there is a way ( table ) in whish we can have moment values every 0.50m.

Thank you

Product Support
5,718 Posts
1,303 Kudos
Registered: ‎04-26-2010

Re: panel cut

12-24-2012 02:39 AM in reply to: faisal.aaouatif

the moment diagram , is there is a way ( table ) in whish we can have moment values every 0.50m.

 


I am afraid there is no such option.



Rafal Gaweda
Mentor
213 Posts
70 Kudos
Registered: ‎10-08-2011

Re: panel cut

12-24-2012 03:11 AM in reply to: Rafal.Gaweda

OK

Thank you VM

Valued Contributor
77 Posts
5 Kudos
Registered: ‎04-12-2012

Re: panel cut

01-10-2014 03:13 PM in reply to: faisal.aaouatif

Here is a hint for you:

 

- select the nodes that lie on the cut (or nodes close to the cut)

- show FE results, select the internal forces of interest

- filter the results to show only results for the selected nodes

- copy the filtered results to a spreadsheet program

 

P.S. Be careful of the order of the filtered results in the table. It might need slight reordering to match the node numbering in the cut.

 

Cheers