panel cut

[faisal.aaouatif]

when using panel cuts , we can study a hole moment diagram for a slab for example.

but , is there any way to extract quickly (automatically) values of moments in defined points (regular distribution of points) belonging to a cut ?

Thx

[Rafal.Gaweda]

See below

[faisal.aaouatif]

Thank you Rafal ,

Moving the mouse cursor over the diagram gives all the values needed.

to clarify my past question , i give the example below :

defining moments on Slab cut with 10 m long : instead of pointing twenty times ( every 0.50m ) the mouse cursor over the moment diagram , is there is a way ( table ) in whish we can have moment values every 0.50m.

Thank you

[Rafal.Gaweda]

the moment diagram , is there is a way ( table ) in whish we can have moment values every 0.50m.

---

I am afraid there is no such option.

[faisal.aaouatif]

OK

Thank you VM

[sergey.churilov]

Here is a hint for you:

- select the nodes that lie on the cut (or nodes close to the cut)

- show FE results, select the internal forces of interest

- filter the results to show only results for the selected nodes

- copy the filtered results to a spreadsheet program

P.S. Be careful of the order of the filtered results in the table. It might need slight reordering to match the node numbering in the cut.

Cheers