3 Kudos
neigaard10

Panel cut table

Status: New Idea
by neigaard10 on ‎09-12-2013 04:46 AM

Hi

 

It would be very helpfull to be able to get panel cuts in table and the ability to copy a panel cut. For instance if you have different models with the same geometry it would be fast if you where able to copy panel cuts into a model. 

 

And also to see the results from more than 14 panel cuts at a time.

 

Also it would help a lot if you could get more than one result at a time. If you need to check both top and bottom envelope.

Comments
by nishchint ‎03-03-2014 04:16 AM - edited ‎03-03-2014 04:18 AM

I second the suggestion in the post above. If a panel cut input table be provided for example with

1. start - end coordinates

2. type of output  - mxx/complex mxx etc

3. type of smoothening

4. cut name

etc in a table.

 

We end up comparing panel cuts acorss various iterations of a fairly large model across many locations and it may help just copying pasting the cut definitons across mulitple robot files. It takes up quite a bit of time to draw all the cuts again. Furthermore it will be nice to sort panel cuts by name in robot .Just a wish. Thank you

 

Regards

Announcements
IdeaStation Guidelines
Review guidelines and best practices
before posting a new idea.