Discussion Groups

Robot Structural Analysis

Reply
Contributor
andlund
Posts: 12
Registered: ‎09-18-2012

Moving loads

206 Views, 3 Replies
10-18-2012 12:25 AM

Hi,

 

I have problem modelling a moving load, im doing a arbitrary vehicle, when I asign a value for FZ its later reduced when I look in the geometry section. I wonder if there is a factor somewhere reducing this value. I would like to use the asigned FZ-value for my calculations , not the reduced one.

 

Regards,

 

Anders

Please use plain text.
Product Support
Artur.Kosakowski
Posts: 4,777
Registered: ‎12-17-2010

Re: Moving loads

10-18-2012 12:46 AM in reply to: andlund

Only if you define some reduction coefficients in the parameters of the route. Reading your question I don't think you defined them. Most likely the load has not been applied in full - I need the file to tell more. Please indicate which vehicle position to look at.



Artur Kosakowski
Please use plain text.
Contributor
andlund
Posts: 12
Registered: ‎09-18-2012

Re: Moving loads

10-18-2012 01:33 AM in reply to: andlund

Attached is the model, the vehicle load is case 72: Travers 

Please use plain text.
Product Support
Artur.Kosakowski
Posts: 4,777
Registered: ‎12-17-2010

Re: Moving loads

10-18-2012 02:39 AM in reply to: andlund

Load direction should be vertical.

 

load direction.PNG

 

If you find your post answered press the Accept as Solution button please. This will help other users to find solutions much faster. Thank you.



Artur Kosakowski
Please use plain text.