Discussion Groups

Robot Structural Analysis

Active Member
7 Posts
0 Kudos
Registered: ‎10-07-2011
Accepted Solution

model merge

424 Views, 1 Replies
12-15-2011 03:51 PM

Is there a way to do a model merge in Robot for two elements that are overlapping? 

Product Support
5,221 Posts
758 Kudos
Registered: ‎12-17-2010

Re: model merge

12-15-2011 11:48 PM in reply to: afellows

Assuming that this is the situation as shown on the attached picture it would be enough just to change Node 2 for Bar 1 from 2 to 3 in the Bar table of graphically move node 2 to the position of node 3 (they will be automatically merged during model generation that is launched before calculations).


If you find your post answered press the Accept as Solution button please. This will help other users to find solutions much faster. Thank you.



Artur Kosakowski