Discussion Groups

Robot Structural Analysis

Valued Mentor
Posts: 491
Registered: ‎11-01-2011

manual and automatic combinations

216 Views, 1 Replies
11-13-2011 11:09 PM

Hi. When I create automatic load combinations and then add a couple of manual combinations, I can't see the automatic combinations when I request the load combination table. I can only see the manual combinations. Is there a way to see all the combinations together in the combination table. Or even to see the automatic alone.

Ali Al-Hammoud
Structural Design Engineer
MZ & Partners Engineering Consultancy
Please use plain text.
Product Support
Posts: 528
Registered: ‎06-23-2008

Re: manual and automatic combinations

11-14-2011 01:18 AM in reply to: AJA14

You can switch between displaynof manual and automatic combination in the table using Table columnts from context menu (right mouse button) or View>Table columns from text menu.



If this post answer your question please click "Accept as Solution". It will help everyone to find answer more quickly! 


Best regards,

Pawel Pulak
Please use plain text.