Discussion Groups

Robot Structural Analysis

Reply
Active Member
zhurukhin
Posts: 7
Registered: ‎03-18-2011
Accepted Solution

Loads applied but displacements and deflections aren't shown

109 Views, 2 Replies
07-06-2012 05:35 AM

Hi!

 

I made calculation of my scheme.

But it looks like only dead load was calculated.

Results from all other loads (vertical and horizontal) give me zero values of forces, displacements and deflections.

What could be the reason?

 

With kind regards,

me

Please use plain text.
Product Support
Rafal.Gaweda
Posts: 5,498
Registered: ‎04-26-2010

Re: Loads applied but displacements and deflections aren't shown

07-06-2012 05:47 AM in reply to: zhurukhin

Check whether these cases are not set as auxiliary.

 

Additional check:

Press Normalize button and \ or change scale

Fx scele : 500 or 100 and find the biggest value -> member

Deformation :change scale -> find the place on structure where it is 



Rafal Gaweda
Please use plain text.
Active Member
zhurukhin
Posts: 7
Registered: ‎03-18-2011

Re: Loads applied but displacements and deflections aren't shown

07-06-2012 06:19 AM in reply to: Rafal.Gaweda

Hi,

 

I've found reason - model generation was swithed off.

After I switch it on it works good.

Anyway, thanx for reply.

Please use plain text.