Robot Structural Analysis Forum
Welcome to Autodesk’s Robot Structural Analysis Forums. Share your knowledge, ask questions, and explore popular Robot Structural Analysis topics.
cancel
Showing results for 
Show  only  | Search instead for 
Did you mean: 

Load Combination Regulations EC7

6 REPLIES 6
SOLVED
Reply
Message 1 of 7
stroxy
716 Views, 6 Replies

Load Combination Regulations EC7

In ULS verification under EC7, partial factors for variable actions may be taken as 1.5 if unfavorable and 0 if unfavorable.  Does the regulation file consider this? I notice only the value of γ-max (=1.5) is defined whilst the field for γ-min is blank.  Please see attached

6 REPLIES 6
Message 2 of 7
Artur.Kosakowski
in reply to: stroxy

When the code combinations are generated they include ones that include only deal loads (live and snow loads with 0 load factors) dead loads and live loads (snow loads with 0 factors) and dead loads with selected live loads (other live loads with 0 load factors) therefore there is no need to put 0s as the load factors in the regulation file.

 

If you find your post answered press the Accept as Solution button please. This will help other users to find solutions much faster. Thank you.

 

 



Artur Kosakowski
Message 3 of 7
stroxy
in reply to: Artur.Kosakowski

 

Thanks Artur, what about the scenario where different limit states recommend different values for γg, as in the attached tables.  How does one incorporate this in the regulations?

Message 4 of 7
Artur.Kosakowski
in reply to: stroxy

The A type with 0.9 for dead loads is used in the PN regulation whereas additional reduction of dead loads due to existence of live loads is used in the Belgium version of Eurocode.

 

If you find your post answered press the Accept as Solution button please. This will help other users to find solutions much faster. Thank you.

 

 



Artur Kosakowski
Message 5 of 7
stroxy
in reply to: Artur.Kosakowski

So if I understand you correctly, that means to check the 2 limit states EQU and STR for example, I will have to run 2 different analysis with the corresponding regulations for each limit state

Message 6 of 7
Artur.Kosakowski
in reply to: stroxy

One analysis with two sets of combinations generated with different regulation files. The steps are shown on the attached picture.

 

If you find your post answered press the Accept as Solution button please. This will help other users to find solutions much faster. Thank you. 



Artur Kosakowski
Message 7 of 7
stroxy
in reply to: Artur.Kosakowski

Many thanks Artur!! 

Can't find what you're looking for? Ask the community or share your knowledge.

Post to forums  

Autodesk Design & Make Report