Discussion Groups

Robot Structural Analysis

Reply
Mentor
GabrieleNovembri1027
Posts: 162
Registered: ‎01-24-2009
Accepted Solution

Italy NTC 2008 add on Mpl,rd,y problem

412 Views, 2 Replies
01-20-2012 01:59 AM

Hi All,

I'm trying to use Italy NTC 2008 for steel and I found some things that I do not understand. In the beams verification the comparison between the plastic moment and the acting moment is calculated as provided in (4.2.13) as the ratio between the acting moment and plastic moment of the section divided by the coefficient 1.05.

In the note enclosed for the beam  No 280 (HE300B profile) is reported a plastic moment of 513.92 kN*m which seems not divided by a factor of 1.05 provided by the NTC in 2008 (4.2.13).

The plastic  moment should be 489.4 kN *m. As the acting moment is equal to -92.66 kN*m the calculated ratio should be 0.1893 instead of 0.1803, or in other words 0:19 and not  0:18.

I don’t know If I am right

Please use plain text.
Member
Massimo.Speziani
Posts: 3
Registered: ‎06-13-2011

Re: Italy NTC 2008 add on Mpl,rd,y problem

01-23-2012 05:20 AM in reply to: GabrieleNovembri1027

Hi Gabriele,             

 

That value could be due to the fact that the seismic combinations are ACC or SIS-ECC. In attachment an example of calculation of Mpl,rd with SIS-ECC and SIS-ULS. The value in case of SIS-ULS is 489.4 kN *m. No gamma reduction is applied for SIS-ECC

 

Best Regards

 

 



Please use plain text.
Mentor
GabrieleNovembri1027
Posts: 162
Registered: ‎01-24-2009

Re: Italy NTC 2008 add on Mpl,rd,y problem

01-24-2012 06:52 AM in reply to: Massimo.Speziani

Hi Massimo,

Thanks fotr the infotmation.

Gabriele

Please use plain text.