Robot Structural Analysis Forum
Welcome to Autodesk’s Robot Structural Analysis Forums. Share your knowledge, ask questions, and explore popular Robot Structural Analysis topics.
cancel
Showing results for 
Show  only  | Search instead for 
Did you mean: 

Instability (of type 3) in RZ direction

9 REPLIES 9
Reply
Message 1 of 10
omar8878
1266 Views, 9 Replies

Instability (of type 3) in RZ direction

Since upgrading to 2012 version I am receiving the 'Instability (of type 3) error' in my model.  I have modified the model many times, but the errors just moves to another node.

 

I even started a new model from the beginning and received the same error.

 

Is this a common problem?

 

thanks

 

Omar

 

9 REPLIES 9
Message 2 of 10
Artur.Kosakowski
in reply to: omar8878

Please try to type instability into the search box and check if one of the posts on this subject answers your question. If you still are not able to determine the source of the instability in your model send the rtd file.



Artur Kosakowski
Message 3 of 10
omar8878
in reply to: Artur.Kosakowski

I have tried going through the various threads relating to the type 3 instability, but still having problems.

 

Please find attached a link to my model:

 

http://www.filemail.com/dl.aspx?id=UTRHFHMVGKJSWWE

 

it would be greatly appreaciated if you could have a look and provide guidance.

 

thanks

 

Omar

 

Message 4 of 10
Artur.Kosakowski
in reply to: omar8878

The word you are looking for is accuracy Smiley Happy

 

Please send me a private message with your email address - I'll send you back the corrected model.



Artur Kosakowski
Message 5 of 10

I have mailed you the model.

 

If you find your post answered press the Accept as Solution button please. This will help other users to find solutions much faster. Thank you. 



Artur Kosakowski
Message 6 of 10
omar8878
in reply to: Artur.Kosakowski

I have not recieved the email yet, so I am assuming that it is too large for my system.

 

Would you be able to send me a link via filemail or similar?

Message 7 of 10
Artur.Kosakowski
in reply to: omar8878

Message 8 of 10
omar8878
in reply to: Artur.Kosakowski

thank you.  that is the problem sorted.  What was I doing wrong?  I have never recieved this error when creating models before ungrading to 2012 version.

 

thanks

 

Omar

 

Message 9 of 10
Artur.Kosakowski
in reply to: omar8878

Have you looked at the pictures I attached to the message 4? I can't tell what was the reason you have separated bars and overlapped panels but I managed to correct these mistakes.



Artur Kosakowski
Message 10 of 10
omar8878
in reply to: Artur.Kosakowski

sorry, I didn't notice the pictures at first.

 

thanks again.

 

Omar

 

Can't find what you're looking for? Ask the community or share your knowledge.

Post to forums  

Autodesk Design & Make Report