Discussion Groups

Robot Structural Analysis

Reply
Active Member
7 Posts
0 Kudos
Registered: ‎07-01-2012
Accepted Solution

Incorrect bar properties

163 Views, 6 Replies
07-01-2012 11:03 PM

I seem to have a recurring problem when trying to model a structure; the object viewer displays different properties (length, nodes, type, location etc etc) for a bar than the specified (and displayed) properties. See attached.

This seems to be a random event and deleting the bar and redrawing does not solve the problem, just another set of properties shows up. It greatly diminishes our confidence in the software to be using the correct member properties during analysis.

Is this a common problem for others? 

Bar properties.PNG

Product Support
5,704 Posts
1,303 Kudos
Registered: ‎04-26-2010

Re: Incorrect bar properties

07-01-2012 11:53 PM in reply to: l-overton

PLease send us model to check



Rafal Gaweda
Valued Mentor
653 Posts
182 Kudos
Registered: ‎09-07-2011

Re: Incorrect bar properties

07-02-2012 12:06 AM in reply to: Rafal.Gaweda

I get this one alot too (couple times a day in 2011, one a day in 2012, and few times a week in 2013)

 

Save the file, close Robot and reopen.  It goes back to normal then

 

Tony

Active Member
7 Posts
0 Kudos
Registered: ‎07-01-2012

Re: Incorrect bar properties

07-02-2012 12:09 AM in reply to: tony.ridley

Thanks Tony,

Yes I had the same problem in 2012 also. Would be nice if there was a reason it did this

Product Support
5,209 Posts
757 Kudos
Registered: ‎12-17-2010

Re: Incorrect bar properties

07-02-2012 12:10 AM in reply to: tony.ridley

Tony's advice should help. We have noticed that some model editing (in particular intersection or generation of nodes along a bar /division/) can cause the Inspector to display incorrect information. This situation is under investigation.



Artur Kosakowski
Valued Mentor
653 Posts
182 Kudos
Registered: ‎09-07-2011

Re: Incorrect bar properties

07-02-2012 12:12 AM in reply to: Artur.Kosakowski

I would add it's a graphical issue only, the results or analysis are still OK. 

Active Member
7 Posts
0 Kudos
Registered: ‎07-01-2012

Re: Incorrect bar properties

07-02-2012 12:12 AM in reply to: Artur.Kosakowski

Thanks Artur,

I will use Tony's solution for now.