Robot Structural Analysis Forum
Welcome to Autodesk’s Robot Structural Analysis Forums. Share your knowledge, ask questions, and explore popular Robot Structural Analysis topics.
cancel
Showing results for 
Show  only  | Search instead for 
Did you mean: 

Flat slabs -Panel cuts and integral values

2 REPLIES 2
Reply
Message 1 of 3
leegsstewart
642 Views, 2 Replies

Flat slabs -Panel cuts and integral values

Hello,

 

I am sure that this is an easy query!

 

When you do a panel cut and get the integral moment values, these are actually for an idealised 1.00m width, irrespective of the the mesh size?

 

And I suspect that if cut through high value at say, column head, will average over?

 

Many thanks!

 

Lee

 

2 REPLIES 2
Message 2 of 3

Hi @leegsstewart

 

When you do a panel cut and get the integral moment values, these are actually for an idealised 1.00m width, irrespective of the the mesh size?

 

No its not correct the integral value is the total value through the cut length .

 

 



Mustafa Hesenow
Senior Structural Design Engineer/MZP
LinkedIn

Message 3 of 3
me1205377
in reply to: leegsstewart

panel cutt.PNG

moustafa elgaar

Can't find what you're looking for? Ask the community or share your knowledge.

Post to forums  

Autodesk Design & Make Report