Construction Phase Combination

[t.sautierr]

Hello,

I'm trying to model a truss structure with phases.

I want to be able to do two kind of things 

1) check every configuration and be able to add, remove, bars, change support type between phases ->ok

2) I want to create combination that contains loads cases from different phases (this in order to into account the history of loading during the construction). Typical example is removing a support after pouring concrete on a metal sheet deck or phased construction of a truss the heigh of which is several floor.

I tried to do that but it seems that the results can be displayed only for bars active in all the phases .... in some example I didn't manage to display any results ... another strange thing : result status is frozen to "non actuel"...

One simple example attached.

[t.sautierr · Accepted solution]

Should have seen before asking ! :

http://forums.autodesk.com/t5/Robot-Structural-Analysis/Load-sequencing-construction-stages/m-p/4568...

http://forums.autodesk.com/t5/Robot-Structural-Analysis/Phase-structures-preserving-combinations-in-...

http://forums.autodesk.com/t5/Robot-Structural-Analysis/Collecting-phases/td-p/3505898

http://forums.autodesk.com/t5/Robot-Structural-Analysis/Stress-results-with-phase-collections/m-p/45...

http://screencast.com/t/spinoktq

TS

[Pawel.Pulak · Accepted solution]

Yes, it is the best to start by searching the existing posts:)

As concerns the status of results "non actuel" (or "out of date") in case of phase structures it will change into "available" after collecting phases.

Regards,