Hello,
In other frame analaysis programmes I have used, when a bar is specified to go from node to node, and 'cuts through' another node, this one does not get any loads from this bar.
However I have modelled a simpl;e 3D grillage, and member 10 shall be idealised to span between node 8 > 107, passing' over' node 81, and is not specified to be connected to it. This member should be hogging over the full length.
However node 81 is attracting load, when I do not want this to occur. Is there a workaround?
Many thanks
Solved! Go to Solution.
Solved by Rafacascudo. Go to Solution.
Rafael Medeiros
Did you find this post helpful? Feel free to Like this post.
Did your question get successfully answered? Then click on the ACCEPT SOLUTION button.