Discussion Groups

Robot Structural Analysis

Valued Contributor
Posts: 75
Registered: ‎09-14-2009
Accepted Solution

assembly reinforcement

230 Views, 1 Replies
10-11-2012 04:26 AM

Can some tell why robot is drawing 2 assembly-top reinforcements at the same location of the main-top reinforcement. Did I forget a setting ?

Thanks in advance

Please use plain text.
Product Support
Posts: 5,115
Registered: ‎12-17-2010

Re: assembly reinforcement

10-11-2012 05:53 AM in reply to: fallright

You can either use the settings as shown on the attached picture or just delete the assembly bars from your beam leaving only the top main ones.


If you find your post answered press the Accept as Solution button please. This will help other users to find solutions much faster. Thank you.

Artur Kosakowski
Please use plain text.