Robot Structural Analysis Forum
Welcome to Autodesk’s Robot Structural Analysis Forums. Share your knowledge, ask questions, and explore popular Robot Structural Analysis topics.
cancel
Showing results for 
Show  only  | Search instead for 
Did you mean: 

about loads combining

6 REPLIES 6
SOLVED
Reply
Message 1 of 7
ivanko2002
462 Views, 6 Replies

about loads combining

Hello everybody……

I tried to find a solution for my question in the topics, but I didn’t find anything.

My question is about combining the loads. I have several groups of loads:

Dead – G1 (1);

Live – Q1 (2);

         - Q2 (3);

Wind – W1 (4);

           - W2 (5);

Snow – S1 (6);

I prefer to use automatic code combinations. So how to tell the program do not aloud simultaneous acting in generated code combinations of these loads: (3) with (4), (3) with (5), (4) with (5), and (3) with (6).

I will be very grateful if someone explains the method step by step.

Thank you very much.

6 REPLIES 6
Message 2 of 7
Rafal.Gaweda
in reply to: ivanko2002

Create new subnatures of LIVE loads for wind and snow, define these W and S cases using them, set correct relations for automatic code combination generation



Rafal Gaweda
Message 3 of 7
ivanko2002
in reply to: Rafal.Gaweda

Thank you for your answer.

I tried to do this by myself, but unfortunately I couldn't understand the logics of the operations of the program. So please, can you explain the process in details.

Thank you again......

Message 4 of 7
ivanko2002
in reply to: ivanko2002

....If I change the NATURE of the wind and snow loads - in generated cobinatins they will get wrong coefficient ψ depending on their nature.....

Message 5 of 7
Rafal.Gaweda
in reply to: ivanko2002

There are always some pros and cons in case of doing nonstandard operations


Rafal Gaweda
Message 6 of 7
ivanko2002
in reply to: Rafal.Gaweda

I'm sorry, but this is stupid.......This option is a basic requirement for using the software......

Message 7 of 7
Rafal.Gaweda
in reply to: ivanko2002

In Robot you can not deal with relations between cases in different natures.


Rafal Gaweda

Can't find what you're looking for? Ask the community or share your knowledge.

Post to forums  

Autodesk Design & Make Report