Revit Structure

Active Contributor
Posts: 37
Registered: ‎09-10-2012
Message 1 of 2 (238 Views)

Structural Stair

238 Views, 1 Replies
10-24-2012 07:37 PM

Hi everyone, 


 I find it’s very hard to handle stairs with Revit Structure because Revit-Stair-function was designed for Architects instead of structural engineers.  For example, structural stairs are under 2-inch topping of arch stair, but Revit-Stair

can’t offset the stair  2-inches, I have to do lots of additional work to finish stairs( it’s really a lot of work). Do you have a special way  to handle this issue? Please see the attached picture for detail.





Posts: 205
Registered: ‎09-03-2010
Message 2 of 2 (204 Views)

Re: Structural Stair

10-28-2012 09:56 PM in reply to: li71we
Just be consistent--if your using RST levels (Bottom and Top) is at TOP OF CONCRETE, there should be no problem. I personaly used structural levels in RST.

Need installation help?

Start with some of our most frequented solutions or visit the Installation and Licensing Forum to get help installing your software.