Revit Structure

Reply
Active Contributor
li71we
Posts: 37
Registered: ‎09-10-2012
Message 1 of 2 (244 Views)

Structural Stair

244 Views, 1 Replies
10-24-2012 07:37 PM

Hi everyone, 

 

 I find it’s very hard to handle stairs with Revit Structure because Revit-Stair-function was designed for Architects instead of structural engineers.  For example, structural stairs are under 2-inch topping of arch stair, but Revit-Stair

can’t offset the stair  2-inches, I have to do lots of additional work to finish stairs( it’s really a lot of work). Do you have a special way  to handle this issue? Please see the attached picture for detail.

 

Thanks

 

Jason

Mentor
engr_mondo
Posts: 205
Registered: ‎09-03-2010
Message 2 of 2 (210 Views)

Re: Structural Stair

10-28-2012 09:56 PM in reply to: li71we
Just be consistent--if your using RST levels (Bottom and Top) is at TOP OF CONCRETE, there should be no problem. I personaly used structural levels in RST.
Regards,

Mondo
Post to the Community

Have questions about Autodesk products? Ask the community.

New Post
Need installation help?

Start with some of our most frequented solutions or visit the Installation and Licensing Forum to get help installing your software.