Revit Structure

Reply
Contributor
mgomaa
Posts: 21
Registered: ‎09-02-2012
Message 1 of 4 (967 Views)
Accepted Solution

Problem in creating Walls

967 Views, 3 Replies
10-02-2012 05:23 AM

When creating a partition wall, the following messages appeared:

 

" Highlighted walls overlap. One of them may be ignored when Revit finds room boundaries. Use Cut Geometry to embed one wall within the other."  or

 

" None of the created elements are visible in 3D View: {3D} View. You may want to check the active view, its Parameters, and Visibility settings."

 

What`s the problem ?:smileyindifferent:

 

 

 

A partition wall is a non-bearing wall. So it won't show up in your default 3D view... or in nother views with it;s discipline on Structural. Change the disipline of the the view, or the structural usage of the wall.

 

Regards Jordi

*Expert Elite*
CADastrophe
Posts: 3,401
Registered: ‎08-28-2009
Message 2 of 4 (963 Views)

Re: Problem in creating Walls

10-02-2012 06:35 AM in reply to: mgomaa

Sounds like a simple visibility issue. Likely causes are:

 

  • The Walls Category is turned off.
  • A View FIlter under V/G is turning the Wall off.
  • The current Workset is turned off.
  • View Range: Cut Plane is above the Wall.

See if any of the above is the cause. If not, just reply back.

Corey D.                                                                                                                  ADSK_Logo_EE_2013.png    AutoCAD 2014 User  Revit 2014 User
──────────────────────────────────────────────────────────────────────
⁞|⁞ Please use Mark Solutions!.Accept as Solution and Give Kudos!Give Kudos as appropriate to further enhance these forums. Thank you!
Active Contributor
5kings
Posts: 37
Registered: ‎09-27-2012
Message 3 of 4 (958 Views)

Re: Problem in creating Walls

10-02-2012 07:26 AM in reply to: mgomaa

A partition wall is a non-bearing wall. So it won't show up in your default 3D view... or in nother views with it;s discipline on Structural. Change the disipline of the the view, or the structural usage of the wall.

 

Regards Jordi

Contributor
mgomaa
Posts: 21
Registered: ‎09-02-2012
Message 4 of 4 (945 Views)

Re: Problem in creating Walls

10-03-2012 03:27 AM in reply to: 5kings

Thanks Jordi , Problem solved :smileyhappy:

Post to the Community

Have questions about Autodesk products? Ask the community.

New Post
Announcements
Are You Going To Be @ AU 2014? Feel free to drop by our AU topic post and share your plans, plug a class that you're teaching, or simply check out who else from the community might be in attendance. Ohh and don't forgot to stop by the Autodesk Help | Learn | Collaborate booths in the Exhibit Hall and meet our community team if you get a chance!