Revit Structure

Revit Structure

Reply
Distinguished Contributor
DParkRMAK
Posts: 131
Registered: ‎12-17-2007
Message 1 of 2 (195 Views)
Accepted Solution

line pattern display for floors

195 Views, 1 Replies
09-28-2012 05:34 PM

In plan views we show the perimeter of floors with a triple dash line which is set in the object syles. This also makes the perimeter of the floors in all other views and sections the same line pattern.

Is there a way to show the triple dash lines only in plan views and show solid lines in all other views without doing an override?

You could create a filter in plan, then create a view template from that filter, then apply the view template to your floor plans where you need the floors to show up differently. See this link for a file the shows the above method https://dl.dropbox.com/u/11938886/AQ_07675013.rvt

 

Look at Levels 1 and 2, the floor edge is dashed because the view template (AQ_Filter) is applied. If you want to turn it off set the view template to none > right click on the floor > override graphics in view > by filter > click on the (Floor) filter and click remove. Its a little bit of work, but its gets you what you want and the floor is not effected in other views.

 

Hope this helps and thanks for posting.

Product Support
alan.quinn
Posts: 631
Registered: ‎09-08-2010
Message 2 of 2 (179 Views)

Re: line pattern display for floors

10-01-2012 01:22 PM in reply to: DParkRMAK

You could create a filter in plan, then create a view template from that filter, then apply the view template to your floor plans where you need the floors to show up differently. See this link for a file the shows the above method https://dl.dropbox.com/u/11938886/AQ_07675013.rvt

 

Look at Levels 1 and 2, the floor edge is dashed because the view template (AQ_Filter) is applied. If you want to turn it off set the view template to none > right click on the floor > override graphics in view > by filter > click on the (Floor) filter and click remove. Its a little bit of work, but its gets you what you want and the floor is not effected in other views.

 

Hope this helps and thanks for posting.



Alan Quinn
Support Specialist
Product Support
Autodesk, Inc.
Post to the Community

Have questions about Autodesk products? Ask the community.

New Post
Announcements
Do you have 60 seconds to spare? The Autodesk Community Team is revamping our site ranking system and we want your feedback! Please click here to launch the 5 question survey. As always your input is greatly appreciated.