Revit Structure

Revit Structure

Active Member
Posts: 6
Registered: ‎01-11-2012
Message 1 of 2 (328 Views)

Beam constrained in two different levels

328 Views, 1 Replies
01-23-2013 07:40 AM

Dear all, thanks in advance,


I'm placing a Beam component into my project.

But the Beam goes from the level 1 to level 2 in the roof (is a single Flange Beam).

as a Reference Level I have  Level 1, and in End Level Offset, I`m trying  to use a formula to constrain the end of the Beam to the level 2.


there is a some way to do this? constrain a beam between 2 leveles?

I tryed this Level2.height or Level1, but it does not work.


anyone help?



Valued Mentor
Posts: 491
Registered: ‎11-01-2011
Message 2 of 2 (316 Views)

Re: Beam constrained in two different levels

01-24-2013 12:30 AM in reply to: carlos.delabarrera

Hi. You should use 3d snapping when creating a beam between 2 levels. Make sure you change the end attachment to distance for both the beginning and the end otherise any changes in the slab and the beam will not follow. Hope this helps.

Ali Al-Hammoud
Structural Design Engineer
MZ & Partners Engineering Consultancy
Post to the Community

Have questions about Autodesk products? Ask the community.

New Post
Do you have 60 seconds to spare? The Autodesk Community Team is revamping our site ranking system and we want your feedback! Please click here to launch the 5 question survey. As always your input is greatly appreciated.