Revit MEP

Reply
Member
bbrovont
Posts: 5
Registered: ‎09-12-2012
Message 1 of 4 (379 Views)
Accepted Solution

Wire Size Label bug

379 Views, 3 Replies
11-05-2012 10:58 AM

I seem to have discovered a bug with the wire size label.  If I edit the wire type so that a neutral is not required, the label stops showing the ground conductor size as well.  I can see it in the properties window, it shows the 3 hot sizes and the ground size, it just will not show up in the view.  Anyone have a suggestion to fix this, or seen this before?

I would make sure that "Share Neutral Conductor" and "Share Ground Conductor" are both unchecked for the wire type. The tag and Properties Palette should now show the correct number of conductors.

Member
bbrovont
Posts: 5
Registered: ‎09-12-2012
Message 2 of 4 (376 Views)

Re: Wire Size Label bug

11-05-2012 11:12 AM in reply to: bbrovont

I just discovered that the wire size parameter in the power system properties shows the correct number of conductors, but the wire size parameter for the actual wire geometry only shows the hot conductors, if there is no neutral.  Hopefully someone else has seen this before, and has a solution.

Product Support
Chris.Aquino
Posts: 413
Registered: ‎06-27-2010
Message 3 of 4 (279 Views)

Re: Wire Size Label bug

11-21-2012 11:58 AM in reply to: bbrovont

I would make sure that "Share Neutral Conductor" and "Share Ground Conductor" are both unchecked for the wire type. The tag and Properties Palette should now show the correct number of conductors.



Chris Aquino
Knowledge Domain Expert
Customer Service & Support
Autodesk, Inc.


The Revit Clinic
@Revitclinic
Member
bbrovont
Posts: 5
Registered: ‎09-12-2012
Message 4 of 4 (131 Views)

Re: Wire Size Label bug

02-18-2014 08:38 AM in reply to: Chris.Aquino

Sorry, Chris.  I hadn't realized that you responded to my post.  Thank you very much, that solved the problem.  I hadn't realized that setting was available.

Post to the Community

Have questions about Autodesk products? Ask the community.

New Post
Announcements
Do you have 60 seconds to spare? The Autodesk Community Team is revamping our site ranking system and we want your feedback! Please click here to launch the 5 question survey. As always your input is greatly appreciated.