Revit MEP

Reply
Contributor
jolieame
Posts: 25
Registered: ‎02-29-2012
Message 1 of 6 (168 Views)
Accepted Solution

Using Filters in Visibility and Graphic Display

168 Views, 5 Replies
03-07-2012 09:13 PM

 I am quite confused about Using Filters in Visibility and Graphic Display, who would let me know the details about this, had better give an example on electrical area.

Thanks!

You are welcome. Check out this video on you tube. It uses ductwork in the demo but the same goes for piping. http://www.youtube.com/watch?v=DDyysnLJJfI

Good luck, Tony :smileyhappy:

Valued Contributor
TonyVav
Posts: 65
Registered: ‎11-13-2006
Message 2 of 6 (148 Views)

Re: Using Filters in Visibility and Graphic Display

03-08-2012 07:48 PM in reply to: jolieame

What are you trying to accomplish with filters? I use them to control visability and color of pipe and duct systems, shading worksets (i.e. Shading mechanical systems on a piping sheet). There are many ways to use filters. :smileyhappy:

Valued Contributor
TonyVav
Posts: 65
Registered: ‎11-13-2006
Message 3 of 6 (145 Views)

Re: Using Filters in Visibility and Graphic Display

03-08-2012 08:07 PM in reply to: jolieame

Also check out wikihelp and youtube.com for help.

Contributor
jolieame
Posts: 25
Registered: ‎02-29-2012
Message 4 of 6 (130 Views)

Re: Using Filters in Visibility and Graphic Display

03-11-2012 06:53 PM in reply to: jolieame

Thank you TonyVav, actually I just begin to learn revit MEP, have not used in any where yet, just feel filter makes me confused, I guess I need read wikihelp more..

Valued Contributor
TonyVav
Posts: 65
Registered: ‎11-13-2006
Message 5 of 6 (128 Views)

Re: Using Filters in Visibility and Graphic Display

03-11-2012 08:14 PM in reply to: jolieame

You are welcome. Check out this video on you tube. It uses ductwork in the demo but the same goes for piping. http://www.youtube.com/watch?v=DDyysnLJJfI

Good luck, Tony :smileyhappy:

Contributor
jolieame
Posts: 25
Registered: ‎02-29-2012
Message 6 of 6 (126 Views)

Re: Using Filters in Visibility and Graphic Display

03-11-2012 08:30 PM in reply to: TonyVav

Thank you Tony, I need look at it…it would be helpful...

Post to the Community

Have questions about Autodesk products? Ask the community.

New Post
Need installation help?

Start with some of our most frequented solutions or visit the Installation and Licensing Forum to get help installing your software.