Revit MEP

Posts: 25
Registered: ‎08-17-2012
Message 1 of 3 (218 Views)
Accepted Solution

Splitting a pipe Revit 2012

218 Views, 2 Replies
01-07-2014 12:41 PM

I cant seem to break a pipe in revit 2012.

The split with gap doesnt work. The split adds a socket or a flange (depending on routing preferences), but mends itself when the fitting is deleted.

To wrap a beam or a duct, I am cutting a tee into the pipe to run around the obstruction, then deleting between the tees and converting the tees to elbows!

There must be a better way!



*Expert Elite*
Posts: 352
Registered: ‎10-14-2008
Message 2 of 3 (211 Views)

Re: Splitting a pipe Revit 2012

01-07-2014 01:18 PM in reply to: alatier
I don't think Split with Gap has ever worked correctly for MEP items unfortunately. If you split the pipe and then drag the ends away from the union it places, it shouldn't reconnect. Annoying I know.
Posts: 25
Registered: ‎08-17-2012
Message 3 of 3 (204 Views)

Re: Splitting a pipe Revit 2012

01-07-2014 01:49 PM in reply to: abulla

Thanks Abdulla

You are saying thatr the best solution to adding a wrap is to split the pipe either side of the obstruction, then delete the pipe and the added sockets/couplings/flanges then re-route the pipe?

If this is the case, I hope they improve it in new versions



Are you familiar with the Autodesk Expert Elites? The Expert Elite program is made up of customers that help other customers by sharing knowledge and exemplifying an engaging style of collaboration. To learn more, please visit our Expert Elite website.
Need installation help?

Start with some of our most frequented solutions or visit the Installation and Licensing Forum to get help installing your software.