Revit MEP

Reply
Active Contributor
c.era
Posts: 26
Registered: ‎01-06-2012
Message 1 of 3 (587 Views)

Spaghetti!!

587 Views, 2 Replies
10-24-2012 07:24 AM

Does anyone have an easy way to utilize spaghetti on drawings? Can you break it where it crosses without getting homerun arrows? I want to use wires but they are not very user friendly for me - any suggestions help. I am an advocate for just putting panel and circuit info next to the device but we have people in our company that want to see spaghetti and always retort 'I CAN DO IT IN AUTOCAD!"' Thoughts?

*Expert Elite*
CADastrophe
Posts: 3,421
Registered: ‎08-28-2009
Message 2 of 3 (549 Views)

Re: Spaghetti!!

10-26-2012 07:31 AM in reply to: c.era

We don't show this wiring on our drawings, but we will eventually have to show some (required by some local codes for EM lighting and such).

 

There seems to be a setting "Gap of Wiring Crossing" under Electrical Settings » Wiring, but I can't get the Wiring to break at all. Also, there are a number of graphical issues regarding Wiring, such as not terminating the Wire on the boundary of a Family represented by an embedded Generic Annotation. I would recommend searching this forum because there are many posts full of reports, methods, and other info regarding Wiring.

 

I have tagged a small number of posts: Tag "Wire"

Corey D.                                                                                                                  ADSK_Logo_EE_2013.png    AutoCAD 2014 User  Revit 2014 User
──────────────────────────────────────────────────────────────────────
⁞|⁞ Please use Mark Solutions!.Accept as Solution and Give Kudos!Give Kudos as appropriate to further enhance these forums. Thank you!
Product Support
Chris.Aquino
Posts: 413
Registered: ‎06-27-2010
Message 3 of 3 (512 Views)

Re: Spaghetti!!

11-02-2012 09:01 AM in reply to: CADastrophe

The Wire Gap settings will only display if Hardware Acceleration is Enabled in the Revit Options.

 

As for the wires and the nested annotation symbol, this is a wish request that has already been logged.



Chris Aquino
Knowledge Domain Expert
Customer Service & Support
Autodesk, Inc.


The Revit Clinic
@Revitclinic
Post to the Community

Have questions about Autodesk products? Ask the community.

New Post
Announcements
Do you have 60 seconds to spare? The Autodesk Community Team is revamping our site ranking system and we want your feedback! Please click here to launch the 5 question survey. As always your input is greatly appreciated.