Revit MEP

Reply
Mentor
michaelmead
Posts: 278
Registered: ‎03-02-2012
Message 1 of 6 (307 Views)
Accepted Solution

sloped ductwork tag

307 Views, 5 Replies
02-14-2013 07:58 AM

So I have a lot of duct that is sloped for offset purposes. Is there away to write a tag that will say what the slope angle is for these ducts? If so how do you do it? Thanks!

*Expert Elite*
abulla
Posts: 352
Registered: ‎10-14-2008
Message 2 of 6 (303 Views)

Re: sloped ductwork tag

02-14-2013 08:31 AM in reply to: michaelmead

A Spot Slope will work for that. I'm not sure about incorporating it into a duct tag though.

Mentor
michaelmead
Posts: 278
Registered: ‎03-02-2012
Message 3 of 6 (298 Views)

Re: sloped ductwork tag

02-14-2013 08:51 AM in reply to: abulla

What is a spot slope?

Mentor
michaelmead
Posts: 278
Registered: ‎03-02-2012
Message 4 of 6 (293 Views)

Re: sloped ductwork tag

02-14-2013 09:19 AM in reply to: michaelmead

I need something that can be taged.

*Expert Elite*
abulla
Posts: 352
Registered: ‎10-14-2008
Message 5 of 6 (290 Views)

Re: sloped ductwork tag

02-14-2013 09:35 AM in reply to: michaelmead

On the Annotate tab, there's a Spot Slope button that you can use to tag the slope of pretty much anything, including duct.

 

Mentor
michaelmead
Posts: 278
Registered: ‎03-02-2012
Message 6 of 6 (278 Views)

Re: sloped ductwork tag

02-14-2013 10:27 AM in reply to: abulla

THANKS!

Announcements
Are you familiar with the Autodesk Expert Elites? The Expert Elite program is made up of customers that help other customers by sharing knowledge and exemplifying an engaging style of collaboration. To learn more, please visit our Expert Elite website.
Need installation help?

Start with some of our most frequented solutions or visit the Installation and Licensing Forum to get help installing your software.