sloped ductwork tag

[revitworkbench]

So I have a lot of duct that is sloped for offset purposes. Is there away to write a tag that will say what the slope angle is for these ducts? If so how do you do it? Thanks!

[abulla]

A Spot Slope will work for that. I'm not sure about incorporating it into a duct tag though.

[revitworkbench]

What is a spot slope?

[revitworkbench]

I need something that can be taged.

[abulla · Accepted solution]

On the Annotate tab, there's a Spot Slope button that you can use to tag the slope of pretty much anything, including duct.

[revitworkbench]

THANKS!