So I have a lot of duct that is sloped for offset purposes. Is there away to write a tag that will say what the slope angle is for these ducts? If so how do you do it? Thanks!
Solved! Go to Solution.
Solved! by abulla. See the answer in context.
On the Annotate tab, there's a Spot Slope button that you can use to tag the slope of pretty much anything, including duct.
Access a broad range of knowledge to help get the most out of your products and services.
Start with some of our most frequented solutions or visit the Installation and Licensing Forum to get help installing your software.
Upgrading to a 2015 product? Make sure to check these out 1st!