Revit MEP

Reply
Mentor
michaelmead
Posts: 286
Registered: ‎03-02-2012
Message 1 of 6 (317 Views)
Accepted Solution

sloped ductwork tag

317 Views, 5 Replies
02-14-2013 07:58 AM

So I have a lot of duct that is sloped for offset purposes. Is there away to write a tag that will say what the slope angle is for these ducts? If so how do you do it? Thanks!

On the Annotate tab, there's a Spot Slope button that you can use to tag the slope of pretty much anything, including duct.

 

*Expert Elite*
abulla
Posts: 358
Registered: ‎10-14-2008
Message 2 of 6 (313 Views)

Re: sloped ductwork tag

02-14-2013 08:31 AM in reply to: michaelmead

A Spot Slope will work for that. I'm not sure about incorporating it into a duct tag though.

Mentor
michaelmead
Posts: 286
Registered: ‎03-02-2012
Message 3 of 6 (308 Views)

Re: sloped ductwork tag

02-14-2013 08:51 AM in reply to: abulla

What is a spot slope?

Mentor
michaelmead
Posts: 286
Registered: ‎03-02-2012
Message 4 of 6 (303 Views)

Re: sloped ductwork tag

02-14-2013 09:19 AM in reply to: michaelmead

I need something that can be taged.

*Expert Elite*
abulla
Posts: 358
Registered: ‎10-14-2008
Message 5 of 6 (300 Views)

Re: sloped ductwork tag

02-14-2013 09:35 AM in reply to: michaelmead

On the Annotate tab, there's a Spot Slope button that you can use to tag the slope of pretty much anything, including duct.

 

Mentor
michaelmead
Posts: 286
Registered: ‎03-02-2012
Message 6 of 6 (288 Views)

Re: sloped ductwork tag

02-14-2013 10:27 AM in reply to: abulla

THANKS!

Post to the Community

Have questions about Autodesk products? Ask the community.

New Post
Need installation help?

Start with some of our most frequented solutions or visit the Installation and Licensing Forum to get help installing your software.