Revit MEP

Valued Contributor
Posts: 86
Registered: ‎10-15-2012
Message 1 of 2 (185 Views)
Accepted Solution

Revit to use modified families automatically

185 Views, 1 Replies
11-27-2012 02:01 AM



I have modified the OOTB square to round fitting by simply deleting the flange from the round end, as it is not required. Question is, how do I get Revit to automatically use this modified fitting instead of the original one, so that I don't have to manually exchange fittings after they have been automatically drawn.



*Expert Elite*
Posts: 3,230
Registered: ‎08-28-2009
Message 2 of 2 (176 Views)

Re: Revit to use modified families automatically

11-27-2012 05:47 AM in reply to: lsop1409

The default fittings to be used are defined under Type Properties for each Duct Type. This applies to Pipe, Conduit, and Cable Tray as well.

Corey D.                                                                                                                  ADSK_Logo_EE_2013.png    AutoCAD 2014 User  Revit 2014 User
⁞|⁞ Please use Mark Solutions!.Accept as Solution and Give Kudos!Give Kudos as appropriate to further enhance these forums. Thank you!
Are you familiar with the Autodesk Expert Elites? The Expert Elite program is made up of customers that help other customers by sharing knowledge and exemplifying an engaging style of collaboration. To learn more, please visit our Expert Elite website.
Need installation help?

Start with some of our most frequented solutions or visit the Installation and Licensing Forum to get help installing your software.