Revit MEP

Reply
New Member
iroi1998
Posts: 1
Registered: ‎04-07-2011
Message 1 of 2 (354 Views)

Revit MEP 2012 Round duct fittings coefficients METRIC

354 Views, 1 Replies
11-23-2011 02:25 AM

Hello!

 

I am having a problem with a pressure drop calculation in Revit for round duct. When working with Imperial template loss coefficients are defined accordingly and all works fine, but when you switch to Metric template, it looks like Revit can't read any information about the diameter of the pipe and can't define the coefficient. If you check the tbl file for lets say CD3-11 or other round duct fitting, you might notice that the information provided in inches and (mm). I tried different scenarios like editing .tbl files and ashrae.xml, but though still can't get it working. I believe that the issue is caused by project units.

 

Is there anyone with similiar problem ? Is there maybe any fix for it ?

Active Member
mrimmer
Posts: 9
Registered: ‎09-01-2005
Message 2 of 2 (173 Views)

Re: Revit MEP 2012 Round duct fittings coefficients METRIC

03-12-2013 11:27 PM in reply to: iroi1998

Hello!

 

I have the same problem. Did anyone find some solution? I think the problem is with all tbl files where are used metric dimensions.

 

 

Announcements
Are you familiar with the Autodesk Expert Elites? The Expert Elite program is made up of customers that help other customers by sharing knowledge and exemplifying an engaging style of collaboration. To learn more, please visit our Expert Elite website.
Need installation help?

Start with some of our most frequented solutions or visit the Installation and Licensing Forum to get help installing your software.